Panasonic DVD-RV80 - Manual (Page 33)

Connecting an amplifier with 5.1-channel audio input terminals
This unit has a built-in Dolby Digital/DTS Digital Surround decoder so you can enjoy surround sound encoded with these systems without having to
connect this unit to an amplifier with a decoder. The amplifier must have 5.1-channel discrete input terminals.
■ Digital signals that can be decoded
Dolby Digital DTS Digital Surround
DVD-RV80 ✓ ✓
DVD-RV60 ✓
iisUse the connection described in Q on page 34 to enjoy DVDs encoded with DTS.
Audio cable
•Connect cables to terminals corresponding to the speakers you
have connected.
£
S
Ê
o
E
o
■Amplifier with 5.1-channel audio input terminais
• Read the instructions for the amplifier and speakers for
connection details.
Speakers
{You can connect from 3 to 5 speakers including the front two.)
• Front speakers (UR)
• Center speaker
•Surround speakers (L/R)
•Subwoofer
When you have finished connection
• In “8 Speaker Setting", select “1 Multi-channel” and make changes to suit your speakers page 38).
Speaker presence: Select “Yes” if the corresponding speaker is connected.
Select “No” if the corresponding speaker is not connected.
Center and surround speaker delay time (Doiby Digital DVD only): Adjust if you cannot place your speakers in the optimum position.
Channel balance: Adjust the output level of the speakers to make up for differences in volume caused by differenf types of speaker or distance.
• Go to “7 Digital Audio Output” and set “1 PCM Down Conversion” to “No” page 36).
Esa
•Turn off V.S.S. {^ page 22) if you have connected a subwoofer, center speaker, or surround speakers as well as the front speakers. Sound will not
come from the other speakers if V.S.S. is on.
VQT8621