Panasonic OMNIVISION PV-S4670 - Manual (Page 27)

VCR Plus+ Programming
Check list before you begin.
^ The clock is set.
□ One Time VCR Setup is complete.
(See pages 10-14.)
d VCR Plus+ Set Up is complete. (See page 26.)
Multi Function Dtaplay
VCR Plus+
I
O
Push VCR Plus+
to display the VCR
Plus+ screen.
ENTER,VCR PLUSCODE
TO END PUSH VCR Ptus+
Push the Numbered Keys to
enter the PlusCode number.
• Refer to your local TV listings.
VCR Ptos+
ENTER VCR PLUSCODE
123456
TO CORRECT PUSH CLEAR
TO ENTER PUSH VCR Plus+
To make corrections
Push the CLEAR button repeatedly to delete the PlusCode number.
Then, enter the correct number.
CLEAR
jiMiftifc COUNTER
VCRTV nrMT
Gl O O o-
TinqjMM stow PAki^t
O © ©
__ J
SPEED
Use normal Timer Recording steps if:
• the PlusCode for a program is not listed.
• you anticipate the program, such as a sporting
event, to run over the scheduled stop time.
See page 21 to;
• Cancel a timer recording in progress
• Replace program contents
• Review or Clear program contents once set
Important notes when using
a DSS receiver.
• When recording programs via a DSS receiver
the DSS receiver must be left on.
• When recording programs via an antenna or
cable, the DSS receiver must be turned off.
VCR Plus+
Push VCR Plus+
to lock in your
program.
Push 1, 2 or 3 Key to
select the program type.
VCR PIUS+
1 ONETIME
2 DAILY (MON-FRI)
3 WEEKLY
TO SELECT PUSH 1,2 OR 3
TO END PUSH VCR Plus-f
To change the recording speed:
Push the SPEED button for SP, LP or SLP.
To cancel program contents:
Push the CLEAR button.
DATE START STOP CH
____SLP
TO CHANGE RECORD SPEED
PUSH SPEED KEY
TO CANCEL PUSH CLEAR
TO END PUSH VCR Plus*
• If you use Connection Method 1 on page 10, the channel
shown in the on-screen display in this step will always be
the cable box output channel number.
VCR PIUS+
Push VCR Plus+
to complete the
program.
When recording programs via a cable
box, make sure the cable box is left on.
If the cable box can not be controlled
with the VCR, you must manually select
the desired channel.
TURN VCR OFF
FOR TIMER RECORDING
AND
LEAVE CABLE BOX POWER ON
This display may differ
depending on your
cable box hook-up.
Push VCR
POWER off to
set the timer.
Multi Function Display
-¡¡EI12-
For a list of publications that carry the PlusCode numbers in your area, call 1 - 800 - 258 - 4827.
You can obtain unlisted PlusCode numbers by calling 1 - 900 - 454 - 7587. Call costs approximately $.95 per minute.
VCR PlusCodes can not be used to program the VCR to record DSS channels.
Avoid overlapping program times.
An on-screen display wrill indicate if an invalid PlusCode number has been entered.
An on-screen display will indicate when all timer programs are full.
27