Routine care of cleaner, Warntng, Replaang – Panasonic Ultra Pro MC-V300 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ROUTINE CARE OF CLEANER

Performing the following tasks will keep your new Panasonic vacuum cleaner operating at peak
performance levels and will ensure these high levels for years to come. Check the BEFORE
REQUESTING SERVICE section in this manual for recommendations on performing some of

these tasks to help solve various problems that may occur.

A

WARNtNG

Electrical Shock or Personal Injury Hazard.

Always disconnect electrical supply before performing any service and/or cleaning of the

vacuum cleaner. Failure to do so could result in electrical shock or personal injury from

cleaner suddenly starting. DO NOT operate the cleaner without the secondary filter. Be
sure the secondary filter is properly Installed. Failure to do so could result in motor fail­
ure.

f

=

e

Sacandary |

lectrostatlc

Filter

The white and grey secondary electrostatic filter

must be replaced when dirty. It should be
replaced regularly depending on use condi­

tions. The filter CANNOT be washed as It.

will lose its dust trapping ability. If the
secondary electrostatic filter, located at
the bottom of the bag cavity is dirty,

remove it by pulling forward out from

under the ribs. Replace the filter, white side
up, by sliding it back into place under the .

ribs in the bag cavity.

‘This filter cannot be cleaned and should be. replaced at least four times each year if the
cleaner is used at least one hour each day.

REPLAaNG

'■■i-.Sli.: ÌSS-;

.-STB_____ _..

The white electrostatic exhaust filter must be

replaced when dirty. It should be replaced regularly

depending on use conditions. The filter CANNOT

be washed as it will lose its dust trapping ability.
Press the handle release pedal to let the upper por­
tion of the cleaner lay back against the floor. Grasp
the exhaust panel with a hand on each side, press
inward and pull the panel forward. Lift the white

electrostatic filter to remove. Replace the electrosta­

tic filter, carefully positioning it so the slits fit around
the four raised pins. Replace the exhaust panel.

Return the cleaner to the upright position.

*This filter cannot be cleaned and should be replaced at least four times each year if
the cleaner Is used at least one hour each day.

-

12

-

Advertising