Batteries, Cleaning, Cables – Panasonic KX-E2000 User Manual

Page 48: Batteries • cleaning, Cautions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CAUTIONS

Be sure that the carrier stopper which holds the printer stationary during shipping is removed

before turning the unit on.

Be sure to keep this stopper so that the unit can be transported safely, if the need arises.

For the best possible operation of your typewriter, do not use a power outlet which is presently
being used for a copier or other device which consumes a large volume of power.

Do not use your typewriter in the following environmental conditions:

In direct sunlight where additional heat will be generated.

In areas where the atmosphere is extremely salty or where corrosive gases are present.

• On surfaces that are not flat, or subject to vibration.

Batteries

If improperly used, the batteries may leak and cause corrosion.

Therefore, observe

the

following:

Insert batteries properly so that the polarity matches the plus (+)

and minus (-) positions indicated in the bottom of the battery
compartment.

• Do not use new and old batteries together.
• Do not use batteries of different types together. Some batteries

differ in voltage, even though they have the .same shape.

• Do not attempt to recharge the batteries.

Cleaning

Use only a soft, dry cloth to clean your typewriter. Water or
thinners may damage the cover, case, or electronic circuitry.

Cables

The Parallel Interface (KX-EIP2) requires a shielded cable less,

than

6

V

2

feet in length.

41

Advertising