Software preparation, First time only), Using the dvd-rom drive pack in the ms-dos mode – Panasonic CF-VDD721 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Software Preparation
(first time only)
tWJnSovi^s^sillw^
Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] - [CD-ROM] - [MATSHITA DVD-ROM SR-**** ] - [Settings]. Make the set
tings if they have not yet been made.
• Add a check mark for [DMA].
• Set both [Start drive letter] and [End drive letter] in [Reserved drive letters] to [L:].
note
)-
When using CF-71 series
• i
} (with the FIRSTAID CD included): When reinstalling, refer to the
above to set the reserved drive letters of the DVD-ROM drive.
• When booting up from the FIRSTAID FD (for example, to reinstall the operating
system), the DVD-ROM Drive does not have to be replaced by the CD-ROM Drive
(CF-VCD711). The CD-ROM driver will recognize the DVD-ROM Drive.
Confirm that [Transfer Mode] is set to [DMA if available] in [Control Panel] - [System] -
[Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] - [Secondary IDE Chan
nel] - [Advanced Settings] - [Device 0]. Perform this setting if it has not yet been made.
Using the DVD-ROM Drive Pack in the MS-DOS Mode
¡smnwiimaeB.)
To use the DVD-ROM Drive Pack in the MS-DOS mode, configure the drive following the
steps below after performing the above preparations. If the steps listed below are per
formed without completing above preparations first, the drive will not operate prop
erly.
1
Click the [Start] button then select [Shut Down].
2
Select [Restart in MS-DOS mode] and click [OK].
3 Open the “CONFIG.SYS” file for editing by issuing the following commands:
c d \ f
Enter )
edit config.sys (
Enter
М