Connecting procedures, A. ibm ps/2 or compatible models, B. apple computer – Panasonic SL70 User Manual
Page 10: Connection of ac power suppiy, Precaution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
^Connecting Procedures
Turn off your computer.
Connect the signal connectors as shown below.
Turn the monitor on, then turn on the computer.
A. IBM PS/2 or compatible models
Rear view
0 Connect the supplied signal cable to the
monitor's port.
0 Connect the other end of the AC power cord
to a grounded power outlet.
15-pin mini
D-Sub cable
B. Apple computer
Use a UNIMAC-82D MAC adapter.
Panasonic MAC adapter
If you need an adapter and one is not provided
by your dealer,
call 1-800 PANASYS (1-800-726-2797).
^Connection of AC Power Suppiy
If the AC power supply voltage is in the range 100 to 240V, either 50Hz or 60Hz frequency can be
used.
There is no AC100V/240V selector switch as selection is automatic.
Precaution:
• In order to use the display unit safely, use a power cord that is properly grounded.
• AC plug cords for the following countries are supplied in the same package.
U.S.A......... UL
Canada......CSA
For use in other countries, make sure the AC cord meets the safety standards of each country.
— 5 —