Panasonic PV-D4734S - Manual (Page 10)

Locaiion OT uonirois ^coniinuea;
Rear View of DECK
Bold: VCR Function
Bold Italic. VCR and DVD Functions
Italic. DVD Function
AC Power Plug
• While plugged into an AC outlet,
this DECK consumes 0.85 W of
electrical power in off mode.
Component Video Output
Connector (Y, P
b , P r )
(DVD Only)
p. 13
VHF/UHF Antenna Output Terminal
p.12
VHF/UHF Antenna Input Terminal
p. 12
Video Output
Connector
p. 12
Video Input
Connector
p.35
Optical Digital Audio—
Output Connector
(DVD Only)
p. 15
S-Video Out Connector-
(DVD Only)
pp. 10, 13
Audio Output 1
Connector (UR)
p. 12
Audio Output 2
Connector (UR)
p. 13
Audio Input
Connector (L/R)
p. 35
The following table shows the status of the output jacks when in VCR or DVD mode.
Video Output
Audio Out 1
Audio Out 2
Component
Video Output
S-VIDEO OUT
VCR YES N/A N/A
DVD YES YES
PROG functions on the remote are not available when using Component Video Output and
S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press PROG.
r To enjoy PROGRESSIVE SCAN video------------------------------------------------------
(1) . Connect Component Video Output to the component video input terminals of a television.
(See p. 13.)
(2) . When PROGRESSIVE OUT is set to “ON" in the DVD Main Menu (p. 55), a Progressive
Scan signal is output from the Component Video Output Connector.
Notes
• The screen may shift off-center when using progressive output. Please adjust the screen
position if this occurs. (Refer to your TV manual.)
• If the television is not progressive compatible, a progressive scan picture is not available.
Connect the Video Output or S-Video Output connector (see p. 12, 13) and
set PROGRESSIVE OUT to “OFF” in the DVD Main Menu. (See p. 55.)
10
For assistance, please call; 1 -800-211 -PANA(7262) or, contact us via the web at http://www.panasonic.CDm/cantactlnfo