Recording motion images – Panasonic DMC-LC20T EN User Manual
Page 27
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recording Motion Images
[Preparations]
® insert the card. (F13)
• Set the power switch to [OPERATE],
(P15)
1
Set the mode dial
to
motion image
mode [¡gl]].
2
Center the subject on the LCD
monitor and press the shutter
button halfway.
« When the focus is adjusted, the
focus indication © [•] appears.
3
Pressing the shutter button fully,
the recording starts.
® The status indicator (2) blinks when
recording the motion image.
* The audio REG starts simuitaneousiy.
® The picture size is fixed at 320 x 240
pixels.
4
Pressing the shutter button fully
again, recording stops.
® If the memory of the card becomes
full during the recording, the
recording is stopped automatically.
® The motion image is recordable for
up to approximately 19 seconds per
capture.
After recording the motion image, the status indicator blinks whiie
recording it in the memory card and after recording it, the status indicator
lights. Do not operate the camera while recording to the memory card.
In motion image mode [[||||], [SENSITIVITY] is set to [AUTO]
automatically and you cannot select [D. ZOOM], [PICT. SIZE] and
[QUALITY].
In motion image mode [¡ffl]], flash mode is set to Forced OFF [^1.
in motion image mode [[|||j], you cannot take pictures with burst mode or
compensate the exposure.
27