Panasonic NI-860R - Manual (Page 7)

The spray may be used with steam or dry ironing,
1. Simply pump the spray button when spray is desired. If the
spray doesn't work immediately just keep pumping till it does.
2. To get a finer spray, pump the button vigorously.
To get coarser spray, pump the button more slowly.
For best results, use a quick, full stroke.
Electronic 3Way AUTO SHUT-OFF FUNCTION
1. When the iron is left unmoved with its solepiate facing
down or on its side for approx. 1. minute,
the iron will automatically shut off power to the heater
by itself.
2. When the iron is left unmoved on its heel rest for
approx. 10 minutes, the iron will automatically
shut off power to the heater by itself.
3. To turn the iron back on to resume ironing, simply move
the iron in any way. Reheat the iron until the indicator
light goes out, if you have left the iron in its auto shut off
mode for 10 minutes or more.
NOTE:
10
minutes
1. The Auto shut off system works regardless of position to "OFF'
of the temperature selector dial, even at "OFF" position.
2. When you finish ironing, always unplug the iron.
iff Licensed under U.S. patent No. 4,686,352 and
foreign counterparts.
minute
to "OFF"
HOW TO USE THE JET OF STEAM FEATURE
The jet of steam feature gives extra steam which goes deep into the garment and is
helpful for removing stubborn wrinkles. The jet of steam feature can be used only in
the " " indication area of the temperature selector dial when steam or dry ironing
(If used at lower setting, water spotting will occur because the iron is not hot enough to
change water to steam). If you have not used the "Jet of Steam" feature for a long time,
it is necessary to clean the inside of the iron before using this feature on any clothes
to be ironed. Simply test the "Jet of Steam" feature several times away from the ironing
board and clothes to be ironed. This will prevent brown spotting or water spotting on
the clothes.
-
7
-