Panasonic EW3122 - Manual (Page 11)

Measurements can be recalled after measurement Is
completed or after the power has been switched off.
• If no measurement values are stored, no value will be shown.
Press the Memory/Recall button for the
person whose data you want to recall.
RECALLING STORED MEASUREMENT VALUES
1
Panasonie
SYS.
imHg
DIA.
imHg
PiMm
8/ 3 /5:30
t3B
83
B5
The average of all measured
values in memory will be shown.
• CSn will be shown at the bottom of the
display.
• For example, if 42 measured values are
stored, the average of the 42 measurements
will be shown. (If only 1 measurement is
stored, the EFl will not be shown.)
• The blood pressure indicator lamps will light
(for approximately 6 seconds).
' Press the Memory/Recall button again.
Each time you press the Memory/Recall button,
the previously stored measurement values will be
shown In order, starting with the newest data.
• The blood pressure Indicator lamps will light
(for approximately 6 seconds).
• If your body moves during measurement, the
body movement Indicator lamp will blink (for
approximately 6 seconds).
On/Off
Sart
^ ITTT
o
Press the Memory/Recall button lightly for only
a short time. If you hold the button pressed for
approximately 3 seconds or longer, all data in
memory will be erased, so please be careful.
O To cancell measurement value recall.
prGSS the On/Off Start button.
• If you forget to switch It off, the blood pressure
monitor will switch off automatically after
approximately 30 seconds.
To let you take measurements at the same time every day, 3 times per day
can be set as notification times.
SEHING (CHECKING) THE MEASUREMENT NOTIFICATION TIME
I IBjpO
on
Press the Set button "1" below the display.
• Notification Time 1 will blink.
* If date and time have not been set, the display
will change to the date/time setting display.
(See p. 11 for setting the date/time.)
Press the Set button "1" again.
• The 4^ and oFF will blink.
Press the Change button "2" to display on.
' The O and on will blink.
' on => Notification sound will sound.
' oFF => Notification sound will not sound.
' When "on" is selected and the Set button is
pressed, the time will show 0=00 and the hour
value will blink, and "z4" and "on" will light.
Press the Change button "2" repeatedly to set
' the desired hour.
19 20