Panasonic NV-F65EA User Manual

Page 34

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising

w m

Keep pressing the Transmit Button and confirm that the
programmed data on the Multi-Function Display of the VTR
are as desired.

After reieasing the button, the data will continue to be
displayed for about 12 seconds.

• If the transmission was not received correctly, the

“Beep-Beep, Beep-Beep” sound from the VTR will warn
you. In this case, perform transmission again.

•The transmission is possible when the VTR is turned on

but is not in any of the recording or playback operation
modes. It is also possible when the VTR is in the timer

recording standby mode (El indication is lit).

•The programming will be done on the next lower unoccu

pied timer programme number (8-1).

• If all programme numbers are occupied, the “Beep-Beep,

Beep-Beep” sound from the VTR will warn you that the
programming cannot be made.

•When the Transmit Button is pressed, the VTR will

automatically be put into the timer recording standby
condition and the VTR will be turned off,

•To operate the VTR before the timer recording will be

performed, press the Timer Rec. Button to suspend the
timer recording standby condition. After using the VTR, be
sure to press the Timer Rec. Button again, otherwise the

timer recording will not be made.

9 More Than One Timer Recording in

Repeat the following operation steps 0~0-

O Trace the “CANCEL" bar code on the Programming

Sheet.

/------------------------------------------------------------------------- ^

CANCEL

B-

Trace the bar codes for “CHANNEL”,
“START TIME” and “END TIME”.

“DATE”,

Confirm that the present time is displayed on the
Multi-Function Display of the VTR, and transmit the
data.

• If the next timer programming data are transmitted

while the previous timer programming data are still
being displayed, the displayed timer recording data
will be cancelled.

After programming a timer recording, the VTR is in the timer
recording standby mode and cannot be used for any other
operation, such as playback. If some other operation is
desired, first trace the “TIMER ON/OFF” bar code and
transmit it to the VTR with the Transmit Button.

To later reset the VTR to the timer recording standby mode,
trace the “TIMER ON/OFF” bar code again and transmit it
with the Transmit Button.

(

)

Advertising