OEM Controls SB25 - Manual (Page 6)

6
At this point, the channel is operating. Continue to hold the joystick handle in
this position and perform the following steps.
Press the Threshold key. The Threshold value is displayed, and it blinks (flashes)
to indicate that it can be adjusted.
Press the Plus key to start or speed up this function if it does not move. Press the
Minus key to stop or slow down the function if it moves too fast.
Press the RUN key to save the new value.
Repeat these steps for adjusting the Threshold in the opposite direction.
To adjust MAXOUT (full speed):
If the machine has two speeds (Dual Range), make sure the High range is
selected. (If this is not possible, then temporarily adjust the Low Range to 100%.
Move the joystick handle fully on (to the end of its travel) in the direction to be
adjusted, and hold it there. Allow time for the machine function to accelerate to
full speed.
Press the Maxout key. The Maximum Output value is displayed and flashes.
Press the Plus key to increase the function speed. Press the Minus key to decrease
the function speed.
Press the RUN key to save the new value.
Repeat these steps for adjusting Maxout in the opposite direction.
To adjust LOW RANGE (a slower speed range):
NOTE - the Maxout adjustment should be made first. The Low Range speed is
affected by the Maxout setting; low range is actually a percentage of the
maximum output.
Select the “low range” machine function. This may be a selector switch or other
device.
Move the joystick handle fully on (to the end of its travel) in the direction to be
adjusted, and hold it there. Allow time for the machine function to accelerate to
full speed.
Press the Low Range key. The Low Range value is displayed, and will be
flashing.