Chicago Electric 90300 - Manual (Page 14)

SKU 90300 For technical questions, please call 1-800-444-3353. PAGE 14
Pre-Start Checks:
1. NOTE: During operation, it may be necessary to refer to the Engine manufacturer’s
Operation, Maintenance, and Parts manual (included) for detailed information about
starting, running, and stopping the Engine.
2. Check to make sure the Engine’s “ON/OFF” Switch is in its “OFF” position.
3. Unscrew and remove the Engine’s Oil Fill Cap located at the bottom of the Engine
Crankcase. Check to make sure the oil level is even with the top of the Oil Fill Hole.
If necessary, add oil until its level is even with the Oil Fill Hole. Then, screw the Oil
Fill Cap back into the Oil Fill Hole. NOTE: Check with the Engine manufacturer’s
manual for the proper type of engine oil required for use.
(See Figure D.)
4. Check the Fuel Gauge (34) for the amount of unleaded gasoline in the Fuel Tank
(32). If necessary, remove the Fuel Tank Cap (37) and refill the Fuel Tank with un-
leaded gasoline. Then, replace the Fuel Tank Cap.
(See Figure E.)
FIGURE D
OIL FILL CAP
FUEL GAUGE (34) FUEL TANK CAP (37)
FUEL TANK (32)
FIGURE E