MagnaFlow JEEP TRUCK GRAND CHEROKEE Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) To begin removal of the OEM
system, unbolt the front two bolt flanges from
the catalytic converter extensions and disengage
the welded hangers from the OEM rubber
isolators. Do not damage the OEM rubber
isolators and save the flange fasteners as they
will be re-used to mount the new exhaust system.
The exhaust system can now be removed by
disengaging the remaining welded hangers from
the OEM rubber isolators. It is also necessary to
remove the tip ball clamps from the OEM system
by twisting to break the tack weld. These clamps
will be re-used to mount the OEM tips.
Step 2: Begin installation of the new system by
fastening the Resonator Assemblies to the
catalytic converter extension pipes and fitting the
hangers into the rubber isolators using the
factory hardware. Leave all clamps and fasteners
loose for final adjustment of the complete
system. Install the X-Pipe Assembly using the
supplied 3.00" clamps. Install the Driver and
Passenger side Muffler Assemblies in a similar
fashion.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and
clearance of frame & bodywork.
(MAGNAFLOW recommends at least 1/2" of
clearance between the exhaust system and any
body panels to prevent heat-related body damage
or fire.)
Step 4: Once a final position has been chosen
for the new system, evenly tighten all fasteners
from front to rear. The supplied band clamps
must be VERY tight to properly align the pipes
and prevent leaks (approximately 40ft-lbs).
Inspect all fasteners after 25-50 miles of
operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15064
2012 Jeep Grand Cherokee SRT8 6.4L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA
92688Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
04/11/12
Rev: 000
P/S Resonator
Assy
D/S Muffler
Assy
X-Pipe
Assy
[4] 3.00"
Clamps
P/S Muffler
Assy
D/S Resonator
Assy