360 Systems Instant Replay 2 - Manual (Page 9)

9
Hot-Keys
There are three primary uses for Hot-Keys:
1. Triggering playback of assigned Cuts
2. As an alphanumeric keyboard
3. Bank selection, using the top row of keys
The main array of 50 buttons are Hot-Keys numbered 1 through 50. A Hot-Key's primary function is
to trigger playback of a Cut assigned to it. Hot-Keys light up whenever their assigned Cut is playing.
In the Bank Select mode, the numbers 1 through 10 on the top row select the corresponding Banks
numbered 1 through 10. The banks are like pages of Hot Keys. They extend the number of cuts that
can be assigned to Hot Keys to 500 ( 50 Hot Keys times 10 Banks ) and also provide a method for
organizing cuts.
Transport Control Buttons
The Transport Controls include S TOP , P LAY , P AUSE and R ECORD . They perform in the traditional
manner of tape recorders.
STOP
STOP Immediately ends recording or playback. STOP will halt some sequential operations, such as
Network Transfers.
PLAY
PLAY Starts playback of the currently selected Cut. Note that pressing P LAY initiates playback
from the beginning of the selected Cut, even if it is already playing. The exception is when P LAY is
used to disengage P AUSE .
RECORD
RECORD Places Instant Replay in Record Ready mode. ( Instant Replay will enter record when the
P
LAY button is pressed.)
LOOP
L OOP causes a Cut to repeat endlessly until either S TOP or L OOP is pressed. S TOP ends playback
immediately. Pressing L OOP exits from the Loop mode, and allows the current Cut to continue
playing to its end. Pressing LOOP while running a Playlist will cause the entire Playlist to loop.
PAUSE
P AUSE interrupts playback of a Cut. When pressed again, playback will resume.