Adaptive Technologies PM-24-6UP-G - Manual (Page 3)

© 2011 Allen Products Company, Signal Hill, CA 90755 USA (562) 424-1100 REV00-020111
Figure 6
Single Speaker Mount:
Step 8: Attach a Speaker Mount to the Arm.
Attach the selected mount’s center hole to the
selected extension arm’s hole using the included ½-
13 x 3.5” or 4.5” long hex bolt, split lock washer,
fender washer, friction washer, and Nyloc nut.
Length of bolts to use depends on the type of
mounts being installed. Make sure the friction
washer is placed in between the arm and the mount
(Figure 6). Rotate mounts/speaker assembly to
desired angle then tighten bolts permanently.
Notes:
Holes on extension arm are 24”, 21” and 18” from
pole adapter.
Step 9: Install and Aim Speaker(s)
Following the instructions of the mount, install and
aim loudspeaker then tighten hardware and angles
permanently.
Step 10: Install End Caps
After installation, cover the end of the arm with the
provided 2 x 2 end cap. Trim end caps if necessary
to clear bolts head and washers.
Step 11: Install Safety Cable
Secure a safety cable to the pole or column and then
attach the other end of the safety cable to the
speaker to bypass the mounting system.
Triple Speaker Mounts:
Step 12: Install Dual Adapter
Install dual adapter to the two holes above extension arm
or in between the extension arm and the support brace
using the hex bolt, flat washer and Nyloc nut provided
with the Dual adapter Kit (Figure 7 and 8).
Note:
Install dual adapter to pole mount before installing to
poles or columns.
Step 13:
Install Pole Mount and dual adapter assembly to poles or
columns (Refer to Step 1-7).
Step 14:
Install the selected speaker mounts on the Pole Mount’s
extension arm and at the ends of the Dual Adapter using
the hex bolts, flat washer, friction washer, split washer
and Nyloc nut provided with the Pole Mount and the Dual
Adapter (Figure 9).
Note:
Make sure speakers mounted on both ends of the dual adapter are of the same weights or with in the same weights.