Using advanced setup utility features, Closing the setup utility – Compaq V6500 User Manual
Page 90
Using advanced Setup Utility features
This chapter describes the Setup Utility features recommended for all users. For more information about
the Setup Utility features recommended for advanced users only, refer to Help and Support, which is
accessible only when the computer is in Windows.
The Setup Utility features available for advanced users include a hard drive self-test, a Network Service
Boot, and settings for boot order preferences.
The “<F12> to boot from LAN” message that is displayed in the lower-left corner of the screen each time
the computer is started or restarted in Windows is the prompt for a Network Service Boot.
The “Press <ESC> to change boot order” message that is displayed in the lower-left corner of the screen
each time the computer is started or restarted in Windows is the prompt to change the boot order.
Closing the Setup Utility
You can close the Setup Utility with or without saving changes.
●
To close the Setup Utility and save your changes from the current session, use either of the following
procedures:
◦
Press
f10
, and then follow the instructions on the screen.
—or—
◦
If the Setup Utility menus are not visible, press
esc
to return to the menu display. Then use the
arrow keys to select Exit > Exit Saving Changes, and then press
enter
.
When you use the
f10
procedure, you are offered an option to return to the Setup Utility. When
you use the Exit Saving Changes procedure, the Setup Utility closes when you press
enter
.
●
To close the Setup Utility without saving your changes from the current session:
If the Setup Utility menus are not visible, press
esc
to return to the menu display. Then use the arrow
keys to select Exit > Exit Discarding Changes, and then press
enter
.
After the Setup Utility closes, the computer restarts in Windows.
82 Chapter 5 Setup Utility