AvaLAN Wireless AW900F User Manual
Page 9
AW900F | AW900F-PAIR
User’s Manual
PAGE 9
Technical Support (650) 384-0000
www.avalanwireless.com
The information on the left is the current status of the radio, while the boxes on the right allow
you to change it. It is important that the IP address of the AW900F is in the same subnet as your
computer. For example, if the subnet mask is 255.255.255.0, the first three number groups of the IP
address must match. Choose the desired parameters and click “Apply.”
5. Make note of the chosen IP address and password, then click “Go to Device Web Page.” This will
cause your default web browser to launch with the device IP address in the browser address bar. Or
you may launch the browser on your own and enter the web page address manually: http://[the IP
address you just set].
Note:
You are not assigning a password, you’re matching the password that
the unit has built into it.
6. The browser page that loads first shows the current device information and provides a login in the
upper right. Log in using the password you just specified (or “password” if you kept the default). If
the login succeeds, you will see an admin page similar to this:
Your computer’s
current IPV4
Ethernet address
Current IP of
AvaLAN Radio
The Device Settings section is where the password, output power, network parameters
are defined and/or reconfigured.
4. Double click the list item that refers to the AW900F being configured. You should see a second
window that is similar to this: