AvaLAN Wireless AW-HSNetAppliance - Manual (Page 11)

PAGE 11 Technical Support (650) 384-0000 www.avalanwireless.com
User’s Manual AW-HSNetAppliance
When the configuration is complete, connect the Net Appliances to available ports on their
respective LANs, the Server on the Main Network LAN and the Client on the Linked Network
LAN and apply power to them. A computer on the respective LAN can be used to browse to the
Net Appliance there to check on the status. An even easier, though less complete way to check
the status is to view the LEDs on the top of the Net Appliance case.
As soon as the units are connected and active, they attempt to connect. The Statistics page
(home page) of each Net Appliance and its LEDs will indicate a status of “Searching.” The
Server will remain in this state until the Client makes connection, then the status will change
to “Connected.” On the Client side, if the Server does not connect after 2 minutes an error
message, “Server is unreachable” will appear.
When the two units are successfully connected, the tunnel can be tested by sending traffic
from a device on one LAN to a device on the other. The Net Appliance Statistics page will show
incrementing counts of transmitted and received data.
Step F. Test the connection