AYRE VX-5 - Manual (Page 12)

button will change the default setting for the
brightness of the status LED as noted below:
One press – Low brightness
Two presses – Medium brightness
Three presses – High brightness
After the ten-second configuration period has
elapsed, the status LED will revert to green (“Mute”
mode).
If no button presses are detected during the ten
second period, the unit will revert to the factory
default setting (high brightness).
Changes to the default settings will also be
transmitted via the AyreLink communication
system to other linked components.
Trigger Control
A trigger control allows one component to control
the low-power consumption mode of another
component. If there are no AyreLink source
components available to control the operation of the
VX-5 amplifier, it may be convenient to use the
trigger control from a source component.
The trigger signal from a source component will
directly control the VX-5 amplifier. The VX-5 can
then in turn control amplifiers linked by the
AyreLink communications system. Connect the
AyreLink ports of your components in a daisy-chain
fashion as described in the chapter “Connections and
Installation” with the VX-5 at one end of the chain.
10