Cannon Instrument CT-1000 (Contant Temperature Bath) - Manual (Page 15)

13
CANNON ® CT-1000 Constant Temperature Bath Instruction & Operation Manual
Revision 3.1e—June, 2011; CANNON ® Instrument Company
2139 High Tech Road • State College, PA • USA 16803
3
BATH OPERATION
NOTE The various functions controlling the bath are printed at the bottom of the
front panel of the CT-1000. These functions, reading from left to right,
are: 1) Power, 2) Temperature, 3) Temperature Adjust, 4) Preheat,
and 5) Limit Control. In this manual the five functions are printed in
boldface upper- and lowercase letters (to match their typeface on the
panel). The switches and dials controlling each function are also printed
in boldface type, but in capital letters (to match their typeface on the
panel).
Turning on the CT-1000
1. Turn the Power BATH switch on.
NOTE The bath heaters will not be activated if there is no liquid in the bath.
2. Set the Limit Control TEMPERATURE ADJUST turn the dial
clockwise to its furthest setting to enable the bath to heat properly.
Proper technique for resetting the dial after the bath reaches operat-
ing temperature is described in the instructional video and in the
following section of the manual
3. Turn on the Power LIGHT switch to illuminate the interior of the
bath.
4. Move the Temperature Adjust SELECT switch to the left.
5. After releasing its lock, move the Temperature Adjust FIXED dial
to 50. Relock the dial.