Safety tips, Setup, Dimensions – Checkline ESMH User Manual

Page 4

Advertising
background image

Model ESMH Motorized Test Stand

3

SAFETY TIPS

■

Wear eye and face protection when testing. Although the ESMH
has relatively slow moving mechanisms, be aware of the dangers
posed by potential energy that can accumulate in a sample during
testing.

■

Keep away from the moving parts of the test stand.

■

Never operate the test stand if there is any visible damage to the
power cord or the control unit. The ESMH is powered by 110/220V
AC current that is present in both the power cord and the control
unit. Any contact with this high voltage can cause serious injury or
even death.

■

Ensure that the control unit is kept away from water or any other
liquids at all times.

■

Make sure the electrical outlet powering the test stand has local
earth ground (3-hole outlet).

■

Opening up the cover of the control unit is not recommended, as
there are no user-serviceable parts inside. If you wish to open it, be
sure to disconnect power before doing so. If any repairs are
needed, contact Mark-10 or your distributor.


SETUP

Mounting to a workbench

Place the ESMH on a clean, flat and level work area that meets the
criteria outlined in the work area safety instructions. For accurate read-
ings, the area should be free of vibrations.

If desired, the test stand can be mounted to the work area with four
5/16 screws.

User’s Guide

8

DIMENSIONS

IN [MM]

2.63 [66.7]

23.25 [590.6]

20.00 [507.9]

5.25 [133.4]

2.00 [50.7]

7.25 [184.1]

2.23 [56.6]

2.23 [56.6]

2.65 [67.3]

0.50 [12.7]

1.30 [33.0]

0.50 [12.7]

#10-32 UNF

X15

0.32 [8.1]

13.10 [330.0]

MAX (BG/EG)

13.50 [343.0]

MAX (MG)

OPTIONAL TRAVEL DISPLAY

Advertising