Checkline BM - Manual (Page 7)

 Electromatic Equipment Co., Inc
-10-
9.0 PRINT SAVED DATA
To print your saved data, connect the device to the printer
using the printer cable that was delivered with your device.
Carefully loose the protection cap on the BM2. At first plug
in the side of the connector with the close plastic casing at
the BM2. Then switch on the device.
Not till then the other side of the cable has to be plugged in
at the printer. Switch on the printer by pressing
. Now the
green LED is blinking. If it does not blink, please change the
batteries and try again.
Press the
button at your BM2 until you reach the menu
(see image on the right). Choose „Print Logs“ and confirm
by pressing
.
Now you can select if you want to print the last saved
measuring series or all saved measuring series (logs).
Confirm by pressing
again. The selected logs are printed
out now.
To save paper, please think of clearing the data storage
regularly.
Online Print and Online Send
Your device supports the function “Online Print” and “Online
Send”, this can be activated in the menu „Options“. If an
option is active, every newly recorded log will immediately
be printed or transferred to the PC after pressing
key.
 Electromatic Equipment Co., Inc
-7-
5.0 CHANGING BATTERIES
Your new device is provided with batteries. Fitting and
changing of batteries:
1. Press with your finger onto the arrow of the battery
cap und pull it back.
2. Remove the empty batteries.
3. Put four new batteries in the device. Make sure that
the positions of the battery poles are correct.
4. Press down the batteries and close the cap.
If the battery symbol appears in the measuring window
resp. if a critical charge of battery is shown in the
status,
the batteries have to be changed
IMMEDIATELY. If you do not use your BM2 device for
a longer period, remove the batteries. For eventual
resulting damages we cannot provide any warranty.
6.0
DETERMINATION OF THE MATERIAL REFERENCE MOISTURE
The principle is a comparison measurement with the dehydration method according
to CEN/TS 14961:2005. Take the measured sample and weigh it. Dry it out in an
oven and weigh it again.
100 %
×
−
=
Mn
Mt Mn
F
M
n
: Mass with average moisture content
M t : Mass of the dried sample
%F: Calculated moisture content