COP-USA CD52W-NV User Manual
Page 8
Operation Manual for Intelligent Speed Dome Camera
ignored the steps 2,3,4,5 while the protocol and address are matching with the controller.
3.
Take out the black liner. (Figure 7)
4.
Based on the ID-CODE shown as Figure 2, set up the protocol used by the camera and the
baud rate as per the state according to Table 1. Check the address of the camera to see if it
is matched with that you need. If not, set the address of the dome camera at corresponding
position as per Table 1.
Takedown the
black liner
Open
Figure 6 Figure 7
5.
Fix the black liner (see Figure 8).
Fixed the
black liner
Figure 8
6.
Take out the cover of the wall-mounting bracket (see Figure 9).
7.
Fix the bracket on the wall (see Figure 10).
8.
Drill the system control wires through the bracket (see Figure 11).
Figure 9 Figure 10 Figure 11
9.
Install the aluminum alloy ball on the
bracket
(
Figure 12
)
.
10.
Rotate the vitreous cover clockwise and mount it
（
Figure 13
）
.
7