COP-USA ASH65NV - Manual (Page 18)

-FAST/-NORMAL/-SLOW. The first three grades are the AutoPan less than 180° while the latter
three grades are the AutoPan larger than 180°. The speed can be adjusted by PAN LEFT/PAN
RIGHT. Push OPEN button to run and exit the menu. The start point and the end point are set from
options 1 and 2 on this menu.
SET TITLE: to edit the titles of preset. Only first 63 presets may have their titles and the preset
number
can be selected by PAN LEFT/PAN RIGHT. Press OPEN button to enter into the edit
state and press CLOSE button to exit the edit state. Operations under the edit state can be seen
thereafter.
SET PATROL: to edit patrol data. Select the number of patrol by PAN LEFT/PAN RIGHT. Press
OPEN button to enter into the edit state and press CLOSE button to exit the edit state. Operations
under the edit state can be seen thereafter.
RUN PATROL: to run patrol function. Select the number of patrol by PAN LEFT/PAN RIGHT.
Press OPEN button to run and exit the menu.
RECORD PATTERN: to recode pattern. It can remember PTZ operation for 40 seconds. Complete
the edit when 40 seconds are up or push CLOSE button.
RUN PATTERN: to playback pattern. You can also control the joystick to stop running.
RETURN: return to the main menu.
3. Appendix of the Manu
Operation of Patrol under the Edit State
After entering into the edit state, the screen shows as follows:
NO – serial number of patrol
POS – number of preset
SP – leaving speed
TM – dwelling time
Enter into edit state, display on screen is as follows:
Edit Area, one line shows data of two point .
SEQ: 01 – it means current set patrol 1
CLOE: EXIT – push CLOSE to exit edit state
The top line and the bottom line display prompt message, and the middle area displays information
of each locus, one line shows data of two points. Move the cursor by PAN LEFT/RIGHT and
modify data by TILT UP/DOWN. Press the button down for 1 second to accelerate. Press CLOSE
button to exit the edit state and store modification. In above figure, the program stores four patrol
points. The settable range of POS is from 1 to 63 or 65 to 128. In case POS is “---“, it means the
skip this point. The settable range of SP is from 0 to 8 (0 and 1 are same at the highest speed while
grade 8 has the lowest speed). The settable rage of TM is from 0 to 99 seconds.
１４