Coway AP-1005AH - Manual (Page 10)

Safety
Information
Operating
Instructions
Troubleshooting
T
ips
C
ustomer
S
ervice
17 18
HOW TO USE CLEANING METHOD
Adjust to desired sensor sensitivity by pressing
airflow selection button. Sensor sensitivity
displayed by twinkling mode display lamp. �
If press airflow selection/modes election
button again more than at the same time,
the product starts working normally and
sensor sensitivity input. �
If there is no button input for 10 seconds,
the value input automatically.
Air quality sensor
On the condition of operation, press airflow
selection / mode selection button more
than 2 seconds at the same time. �
Purity level display lamp on the front side
twinkles in yellowish green color. �
The product is initially set in standard sensitivity. You can adjust sensor sensitivity as like the
following methods when humidity is high, when purity level lamp operates more than 2 hours even not
in the case of severe yellow sand and when purity level lamp keeps green more than 1 hour in the
case of high indoor pollution.
- Make sure to take power plug out prior to filter cleaning.
- Do not use volatile matter or detergent, etc.
- Do not put the product in water or spray water.
Cleaning the air quality sensor (Every 2 Months)
Clean the air inlet and outlet using a
vacuum cleaner or soft brush. ●
Open the particle sensor cover on the
right side of the unit (when facing
the unit). Use a wet
cotton swab to clean
and dry the lens, dust
inlet and dust outlet. ●
Cleaning the negative ion generator (Every 2 Months)
Use a dry cotton swab to remove dust
on the plate. ●
Be careful not to drop the cotton swab into
the unit.
Cleaning the air intake and outlet
Clean the air intake and outlet with a soft
brush. ●
Be careful not to drop the brush into the unit.
Insensibility
Rhythm
Standard
Infant
Sensibility
Automatic
outlet air inlet
dust outlet
dust inlet
�