Chief Manufacturing XSM Series - Manual (Page 10)

XSM/XTM Series Installation Instructions
10
7. Proceed to Adjusting Roll/Height of Wall Brackets
section.
Figure 9
XSM Model
8. Push interface bracket tab all the way down so that the
lower mounting slot is blocked. (See Figure 10)
Figure 10
9. Hang the top hook of interface brackets onto the top bar of
the mount. The bottom of the screen will be away from the
wall.
10. Move screen towards the wall by pulling display bottom
away from wall and pushing the interface bracket tabs up
one notch to the detent which you will be able to feel
(approximately half way up).
11. Push bottom of display toward the wall bracket so that lower
latch on interface bracket surrounds lower bar of wall
mount.
12. Raise interface brackets tabs all the way to secure the
brackets onto the wall mount. (See Figure 10)
Adjusting Roll/Height of Wall Brackets
NOTE: The height adjust wall brackets allow adjustment of
+ 1/2".
1. Turn to right (tighten) to raise side of screen.
(See Figure 11)
2. Turn to left (loosen) to lower side of the screen.
Figure 11
Locking XTM Mount (Optional)
1. Add optional security bracket (L) to the mount.
(See Figure 12)
2. Add padlock (not included) to complete security.
Figure 12
3
6
Top
Hook
(Screen not shown for clarity)
Pull straps
Latch
open
Latch
closed
Interface
bracket
tab
8
12
10
Raises screen
Lowers screen
1
2
(G)
(Screen not shown for clarity)
(L)
1
2
(XTM Shown)