Cub Cadet 7252 - Manual (Page 35)

35
HAZARD BULB REPLACEMENT
Flashing hazard lights are installed on each side of
the ROPS. Replace the bulbs as follows:
• Grasp the outer half of the light housing and
both the front and rear lenses. Accessing the
screws from the notches at the top and bottom
of the outer housing, remove the two screws
fastening the outer and inner housings
together. See Figure 39.
Figure 39
• Remove the outer housing and lenses.
• Push in on the bulb and turn counterclockwise
to remove the bulb from the light socket.
• Align the new bulb with the socket slot, push
the bulb into the socket, and turn clockwise to
lock it in the socket.
• While making certain the lenses engage the
front and rear grooves of the inner housing,
install the lenses and outer housing. Secure
with the two screws.
INSTRUMENT PANEL BULB REPLACEMENT
Referring to the instrument panel information pro-
vided in the CONTROL AND FEATURES section
of this manual, regularly check to ensure that the
instrument panel light bulbs are functioning.
To change a burned out instrument panel bulb:
• Raise the tractor hood to view the back side of
the instrument panel.
• Determine the position of the burned out bulb
and pull the seal plug from the back of the
instrument panel. See Figure 40.
Figure 40
• Using a small flat bladed screw driver in the slot
of the bulb socket, turn the socket approxi-
mately a quarter turn counterclockwise to un-
lock from the instrument panel. Carefully with-
draw from the panel. Note the position of the
bulb socket locking tabs.
• Insert the new bulb/socket assembly into the
instrument panel in the same manner, making
certain the locking tabs of the socket engage
the slots of the instrument panel.
• Turn the socket approximately a quarter turn
clockwise to lock in place and reinsert the seal
plug into the panel opening.
OUTER
HOUSING
INNER
HOUSING
BULB
LENSES
SOCKET
NOTCH
NOTCH
SCREW
Temperature
PTO On
Batt. Charge
Parking Brake
Oil
Pressure
Hazard Lgt. Fuel Gauge
Tachometer
BACK OF INSTRUMENT PANEL