Cub Cadet U-Channel Beam Style User Manual
Page 39
Control valve
35
To replace the valve spring cover:
NOTE: The spring cover part number is 718-0522.
1. Thoroughly clean the valve and surrounding area.
NOTE: Any dirt or debris that gets inside the valve can
destroy it.
2.
Remove both of the socket headed cap screws that
hold the spring cover to the valve using a 5 mm hex
key. See Figure 4.9.
3.
Remove the spring cover.
4.
Carefully remove the old sealant from the valve.
NOTE: Not all of the valves will have sealant under the
spring cover.
5.
Thoroughly clean the exposed area of the valve.
To install the spring cover:
6.
Apply a small bead of Loctite® 515 Flange Sealant or
equivalent compound to the spring cover.
7.
Apply a small amount of releasable thread locking
compound such as Loctite® 242 (blue) to the threads
of the socket headed cap screws.
8.
Install the spring cover and tighten the screws to a
torque of 70 - 90 in lbs (8 - 10 Nm).
9.
Test run the splitter in a safe area before returning it
to service.
Figure 4.9
socket headed
cap screw
Figure 4.10
Sealant