Doepfer MAQ16/3 Sequencer - Manual (Page 26)

Page 26
Event Prg PRG-Change 126 CF 7D
Event Cn1 PRG-Change 127 CF 7E
Event AD1 PRG-Change 128 CF 7F
Remark:
At first one of the three rows must be selected via PRG-Change 1...3, all subsequent
instructions will then refer to that row. The difference between PRG-Change 4/5 and 6/7 is
that PRG-Change 4/5 switches the row ON/OFF globally, whereas 6/7 switches each of the
16 steps ON/OFF individually (This is equivalent to 16 individually sent ON/OFF-instructions
PRG-Change 17...48).
If a step is switched OFF, Note-OFF-events continue to be sent if the row in question has
been assigned to a Note-mode. Only the Note-OFF-events are suppressed. This
arrangement was necessitated by programming considerations.
Noten-Event-Fernsteuerfunktionen
(MIDI-Channel YY here f.e. channel 16 = F)
Row 1 Step 1 Note 36 9F/8F 24 XX
Row 1 Step 2 Note 37 9F/8F 25 XX
...
Row 1 Step 16
Note 51 9F/8F 33 XX
Row 2 Step 1 Note 52 9F/8F 34 XX
Row 2 Step 2 Note 53 9F/8F 34 XX
...
Row 2 Step 16
Note 67 9F/8F 43 XX
Row 3 Step 1 Note 68 9F/8F 44 XX
Row 3 Step 2 Note 69 9F/8F 45 XX
...
Row 3 Step 16
Note 83 9F/8F 53 XX
Remark:
Note-ON instructions switch a step ON, Note-OFF instructions switch a step OFF. This
allows the ON/OFF-switching of sequencer steps by pressing the appropriate keys of a
normal keyboard.
Control-Change Remote-Control
(MIDI-Channel YY)
Controller- Nummer Funktion
0 Velocity Row 1
1 Velocity Row 2
2 Velocity Row 3
3 Tempo
4 Step Position Row 1
5 Step Position Row 2
6 Step Position Row 3
7 Gate Time Row 1
8 Gate Time Row 2
9 Gate Time Row 3