Doepfer MTC64 Midi to Gate Interface (main board) - Manual (Page 5)

MTC64 V2 User’s Guide Page 5
MTC64 is equipped with MIDI In and Thru. The incoming MIDI messages are passed to
MIDI Thru. In this way several MTC64 can be linked together.
MTC64 is available only as an assembled and tested pc board (about 70 x 105 mm).
Three mounting holes for mounting the pc board to a suitable base are available.
We do not offer a suitable housing as the MTC64 is normally installed into the housing of the
device to be controlled by MTC64. An external power supply (7-12V @ min. 100mA) is
required. It is not included with the MTC64. We offer a suitable power supply with European
type of mains plug and 230...240V mains voltage.
We offer a MTC64 connector set. This includes four 16 pin flat cables with 16 pin socket
connectors at one end and one 10 pin flat cable with 10 pin socket connector at one end.
The length for all cables is about 50cm.
You will find the prices for the power supply and connector set in our price list.
We are planning an additional transistor driver board with 16 switching transistors that can
be connected to one of the 16 pin connectors to drive higher loads (up to 500mA and up to
40 V, e.g. lamps, relays, motors, magnets or magnetic valves and so on). This additional
board will probably be available in fall 2001. The power supply required for the loads is not
included.
The configuration of the MTC64 (i.e. MIDI channel, mode, offset and so on) is defined by
the user with 9 jumpers as described below.
Installation of the MTC64 requires some electrical/electronical knowledge by the user.
Please leave the installation of MTC64 to an expert if you are not familiar with electronics.
We take back only MTC64 modules in the original state, i.e. without solder residues, without
scratches and so on.
Please pay attention to the warranty notes on page 2. Ignoring these notes causes warranty
loss and the right to return the goods.