Doepfer MTC64 Power Board - Manual (Page 2)

• No liquids or conducting materials must get into the construction. If this
should happen the board must be disconnected from power immediately
and be examined, cleaned and eventually be repaired by a qualified person.
• Never subject the construction to temperatures above +50 °°°°C or below -10°°°°C.
Before operation the device should have a temperature of at least 10 °°°°C.
• Do not place the device into direct sun light. Do not install the instrument
near heat sources.
• Never use the device in the immediate proximity of other electronic devices
(e.g. monitors, computers) since this could create disturbances within both
devices.
• The MTC64 Power Board may only be used for the purpose described in this
operating manual. Due to safety reasons, the device must never be used for
other purposes not described in this manual. If you are not sure about the
intended purpose of the instrument please contact an expert.