Doepfer Pocket Electronic - Manual (Page 3)

User's Guide Pocket Electronic Page 3
Warranty
• Applying any negative voltage (< 0V) or positive voltage above +5V (> +5V) to one of the 16
analog inputs (JP1, JP2) will destroy the circuit !
• If potentiometers and/or switches are connected between GND and +5V of PE as
described in this manual no problems will occur.
• When external control voltages are connected to PE the user has to pay attention that the
voltages applied are strictly within GND and +5V referenced to GND of PE !
• Do not solder directly to any of the pin headers but use female connectors to make the
connections between PE and the potentiometers, switches or voltages. A cable set that
contains all required connectors and cables is included with PE.
• Carry out all connections in the off-state of PE (i.e. when powered-off only) !
• Do not power on PE (i.e. do not connect the power supply to the corresponding jack socket)
before all 16 analog inputs are connected. Do not leave analog inputs unconnected !
• The 4-pin connector is allowed to connect a button and LED only as described in the
manual. Do not connect any other electronic parts or voltages.
• PE electronics is an electrostatic sensitive device. Avoid any electrostatic charges ! Do not
touch the analog inputs with your fingers !
• Avoid short circuits !
• Ignoring any of these items will cause warranty loss !
• Return of the PE within the 2 weeks return time limit (valid only in Germany) is only possible
if all these items have been met. Return of used cable sets is not possible. We also cannot
take back modules that have been soldered by the user.