Elektron Octatrack - Manual (Page 42)

PROJECTS
30
the AUDIO folder the project folders will appear as empty when exploring them
using the file browser.
THE PROJECT MENU
In the PROJECT menu various project related settings can be made. Press [FUNCTION] +
[MIXER] to open the menu. Four main menus are located to the left. To access their sub-
menus and setting options, select a main menu and press either [ENTER/YES] or the
[RIGHT] arrow key. At the top of the menu the names of the currently active set and project
are visible.
PROJECT
Here commands relating to sets and projects are found. Scroll down in the settings list on
the right hand side by using the [DOWN] arrow key. Select a command by pressing
[ENTER/YES].
CHANGE changes the active project to a new one. When selecting this command and
pressing [ENTER/YES] a list of all projects of the set will appear. Locate the project you
want to load and once found, load it by pressing [ENTER/YES]. Selecting <CREATE NEW
PROJECT> and pressing [ENTER/YES] will create a new project. A naming menu will then
appear.
• It it possible to rename and delete projects while in the CHANGE menu. Press
[FUNCTION] + [BANK] to open a menu where rename and delete options are pres-
ent.
SAVE saves the project. As all changes to a project are automatically cached on card, sav-
ing a project and then reloading it is the only way to return to a specific project state. In
general you should save a project once you are satisfied with it. When performing a SAVE
command the project will be synced to card as well.
RELOAD reloads the project to the state it was saved in.
SYNC TO CARD is a recommended operation before ejecting the Compact Flash card as it
will sync the cache to the card. Removing the card without first card syncing the project
might result in data losses. If a project has been saved using the project SAVE command,
information about the saved state will be written to the card as well.