FRITSCH PULVERISETTE 23 - Manual (Page 18)

5 Initial start-up
Perform initial start-up only after all work as described in Ä Chapter 4
‘Installation’ on page 16 has been carried out.
5.1 Switching on
NOTICE!
Before switching the device on make sure that a grinding
bowl or the transport wood is clamped into the grinding
bowl holder. The loose grinding bowl holder can damage
the housing.
n Connect the external power supply to the mains and the low voltage
plug to the bottom right of the device.
n Switch the device on at the housing. The display lights up.
5.2 Function check
The glass plate has capacitive buttons, which are sensitive
to touch.
n Clamp an empty grinding bowl (see Ä Chapter 6.6 ‘Clamping the
grinding bowls’ on page 24).
n Set a short grinding time and a frequency of approx. 30 Hz with the
corresponding +/- buttons (see Ä Chapter 6.8.1 ‘Setting the vibra‐
tion frequency’ on page 25).
n Press the START button to run the mill at the preselected vibration
frequency.
n The timer counts the time; the time remaining is displayed. At the
end of this time the device will stop.
5.3 Switching off
n Press the STOP button and switch off the main switch.
Initial start-up
- 18 -