4 closing the cutting mill, 5 attaching the collecting vessel, 2 comminution procedure with the protected funnel – FRITSCH PULVERISETTE 15 User Manual
Page 24: Using the device
10.
Repeat the procedure for the third fixed knife.
Make sure the fixed knives are parallel. If they are not par‐
allel, the fixed knives have to be realigned using the pres‐
sure screws.
6.1.4 Closing the cutting mill
Before closing the closing lid, please observe the following:
n
Check whether the cutting rotor and sieve are securely fitted.
n
Clean the conical guide on the cutting rotor.
n
Clean the conical guide in the closing lid.
Close the closing lid and screw it on tightly using the handle. This
engages the safety switch.
6.1.5 Attaching the collecting vessel
Hang the claws of the toggle latches into the flange of the PULVERISETTE
15 and close both toggle levers at the same time; the safety switch
engages.
6.2 Comminution procedure with the protected funnel
Switch on the cutting mill first, and then add material to be
cut.
1.
Close the cutting mill.
2.
Attach the collecting vessel.
3.
Push in the plunger.
4.
Switch on the cutting mill.
Using the device
- 24 -