FRITSCH PULVERISETTE 9 - Manual (Page 19)

n Lift the vibrating cup mill off the transport pallet. The mill stands on
two hollow profiles with 4 device feet (8). It can be lifted by a fork
lift and taken from the transport pallet.
n Place the vibrating cup mill on a flat, stable surface of an interior
room. It does not have to be fastened to the surface.
NOTICE!
Never operate PULVERISETTE 9 while it is standing on the
transport pallet!
n Make sure that the vibrating cup mill is easily accessible.
n The room temperature should be between 0 and 40 °C.
n If the floor is uneven, the machine needs to be levelled by the
adjustable device feet (8) so that the machine stands vertically and
secure.
4.4 Transport securing devices
NOTICE!
Remove the transport securing devices before commis-
sioning the mill.
1. 2 cylinder screws M10x150 are used as transport securing devices
as well as the securing plates on both sides. They are located on
the left and right next to the brackets of the clamping device (3).
2. Use the supplied hex key (SW8) to loosen and remove them.
Installation
- 19 -