Clickfree Wireless - Manual (Page 4)

Clickfree Wireless Backup (Windows) Introducing the Clickfree Wireless
Copyright © 2010 Storage Appliance Corporation. 4
Introducing the Clickfree Wireless
H
OW IT WORKS
Clickfree Wireless backup drive is the easiest way to protect the data on all the PC and Mac
computers connected to your wireless router, with no effort at all, by automatically
searching for and backing up onto its built-in hard disk all the content stored on these
computers. No hardware configuration or software installation is required. It can backup
files on any combination of Windows and Mac computers that are on the same network.
Wireless backup, which is the capability to backup a computer’s files via wireless means
(such as through a home router) onto a backup drive that is not physically connected, is a
significant improvement over all existing backup products. The wireless backup drive can
be stored anywhere within the wireless network, including out of sight of the backed up
drive in a secure location, as well as being able to back up numerous computers within the
wireless network.
BackupLink is the software that resides on your computer that allows the Clickfree Wireless
to wirelessly backup all the files on your computer. Each computer on your network that
will be backed up must have BackupLink installed.
The first time you connect a Clickfree Wireless backup drive to your computer it searches for
and backs up all of your important content, configures itself to the wireless network (if any)
of the computer it is connected to and installs the BackupLink utility which you can access
from your system tray (in the bottom right corner of your screen), a desktop icon, or your
Start menu. The Clickfree Wireless can be attached to any number of computers on the
network to allow them to also be backed up.
When Clickfree has finished installing BackupLink and backing up each computer, to enjoy
the freedom of automatic, wireless backups of every wireless-enabled computer in the
network, just disconnect Clickfree Wireless from all computers and attach it to a power
outlet somewhere within the range of the wireless network. To keep the computers on the
network backed up, just set the automatic scheduler for your preferred day and time and it
will automatically run
Error! Reference source not found. . For instantaneous backup, just
run Clickfree from the icon on the desktop or system tray, and it will look for the Clickfree
Wireless over the network.
Error! Reference source not found.
D
EFINITIONS