Hangar 9 Twist 40 ARF Version 2 - Manual (Page 15)

28 29
Section 13: Linkage Installation (continued) Section 14: Canopy Installation
Step 24
Make a 90-degree bend at the mark made in the last step.
Temporarily connect the pushrod to the throttle arm. Check the
movement of the throttle to verify there is no binding at either
low or high throttle. If there is, make the necessary adjustment
to eliminate any binding.
Step 25
Secure the throttle pushrod to the servo arm using a nylon wire
keeper. Install the throttle servo arm screw when complete.
Required Parts
Fuselage assembly • Canopy •
Required Tools and Adhesives
Canopy glue (PAAPT56) • Sandpaper (medium grit) •
Step 1
Install a pilot of your choosing. Use epoxy to secure the pilot.
Step 2
Position the canopy onto the fuselage. Trace around the
canopy and onto the fuselage using a felt-tipped pen.
Step 3
Lightly sand the inside edge of the canopy and slightly inside
the line drawn on the hatch using medium sandpaper.
Step 4
Apply a bead of Formula 560 Canopy Glue (PAAPT56) around
the inside edge of the canopy. Position the canopy onto the
hatch. Use tape to hold it secure until the glue fully cures.