Installing the i/o connector diagrams – Hardy HI 1769-FC User Manual
Page 13
8
●
●
●
●
●
Chapter 3
Step 4: When you have the modules aligned, press Lever B towards module A to fasten
the connector to Module A.
Connector in locked position
Step 5. The installation is complete.
Installing the I/O Connector Diagrams
About the Module I/O Connector
The I/O Connector at the front of the module connects the module to the Remote
Terminal (RTA), a load sensor, or the HI 2151T series junction box depending on how
many load sensors are installed in the weigh system.
The pin-out diagram is shown below and can be located on the inside of the module door.
Single Channel
Pin 1
Sheild1
Pin 3
C2-1
Violet
Pin 5
C2+1
Gray
Pin 7
Exc-1
Black
Pin 9
Sen-1
Brown
Pin 11
Sig-1
White
Pin 13
Sig+1
Green
Pin 15
Sen+1
Blue
Pin 17
Exc+1
Red
Module connector pin-out diagram