Hardy HI 1769-2WS - Manual (Page 25)

Chapter 3 - Installation
3-7
FIG. 3-5 MODULE CONNECTOR REMOVED
FOR EASIER CABLING
Step 5. Install the cable so it allows the module
door to close.
Step 6. Check to be sure that the wires are
securely connected before operating the
module.
NOTE: Most of the problems with modules are due to loose
connections. Be sure to check the I/O connection first
in the event you have a problem receiving information
from the load cells.
Installing the HI 1769-
WS on a Din Rail Step 1. Pull the two DIN rail fasteners out until
they snap into the open position. (See Fig.
3-6)