Inovonics EE1260 - Manual (Page 2)

© Inovonics, 2011 - www.inovonics.com 2
1. Hold the magnet to the reed switch for less than one quarter of a second, The
LED will light three times to indicate the three-minute walk test has been
activated.
Note: To activate the walk test, the magnet shouldn’t remain near the reed switch for
more than one-quarter of a second.
2. Walk in front of the PIR to test the sensor. The LED will light every time the PIR
senses motion.
3. The unit will not transmit alarm signals during the three minute test period. When
the walk test ends, the LED will light six times.
3.2 Perform Transmission Test
1. Hold the magnet to the reed switch for more than four seconds. The LED will light
three times to indicate the transmission test has been activated.
2. The unit will transmit alarm and restoral cycles at regular intervals for
approximately one minute. The LED will light every time the unit transmits. Ensure
transmissions are received by your network coordinator, receiver or control panel.
4 Operation
The EE1260 transmitter signals an alarm condition when motion is detected by the
sensor.
4.1 Zone Pattern for Standard Lens
The standard wide-angle lens has a coverage pattern of 105°, and covers an area 18
m x 18 m (60 ft x 60 ft). It has a total of 52 zones: (18 long range + 16 intermediate +
ten short range + six nearest range + two creep zones). Optional lenses are available.
Contact Inovonics Wireless technical services.
4.2 Lens Options
The following optional lenses are available for the EE1260:
• ACC672CT curtain lens
• ACC672LR long range lens
• ACC672PA pet alley lens
Note: Mounting height of the EE1260 with standard lens may be anywhere within a
range of 2.1 to 2.7 meters (7 to 9 feet).
Figure 3 EE1260 zone map
5 Specifications
Dimensions: 11.4 8cm x 6.4 cm x 4.1 cm (4.5”H x 2.5”Wx 1.6”D)
Operating temperature: -4° to 60°C (-20° to 140°F)
Humidity: 0 - 90% (non-condensing)
Battery: 3V lithium (CR123A orDL123A)
Tamper: Housing and wall tamper
PIR RF interference immunity: Greater than 30 v/m 26 MHz - 1 GHz
Alarm lockout time: 3 minutes
Mounting height: 2.1 to 2.7 meters (7 to 9 feet)
6 Warranty/Disclaimer
Note: Changes or modifications to this unit not expressly approved by Inovonics
Wireless Corporation may void the installer's authority to operate the equipment as
well as the product warranty.
Inovonics Wireless Corporation ("Inovonics") warrants its EchoStream products
("Product" or "Products") to conform to its own specifications and to be free of defects
in materials and workmanship under normal use for a period of thirty-six (36) months
from the date of manufacture. Within the warranty period, Inovonics will repair or
replace, at its option, all or any part of the warranted Product. Inovonics will not be
responsible for dismantling and/or reinstallation charges. To exercise the warranty, the
User ("User", "Installer" or "Consumer") must work directly through their authorized
distributor who will be given a Return Material Authorization ("RMA") number by
Inovonics. Details of shipment will be arranged directly through the authorized
distributor.
This warranty is void in cases of improper installation, misuse, failure to follow
installation and operating instructions, alteration, accident or tampering, and repair by
anyone other than Inovonics.
This warranty is exclusive and expressly in lieu of all other warranties, obligations or
liabilities, whether written, oral, express, or implied. There is no warranty by Inovonics
that Inovonics product will be merchantable or fit for any particular purpose, nor is
there any other warranty, expressed or implied, except as such is expressly set forth
herein. In no event shall Inovonics be liable for an incidental, consequential, indirect,
special, or exemplary damages, including but not limited to loss of profit, revenue, or
contract, loss of use, cost of down time, or interruption of business, nor any claim
made by distributor's customers or any other person or entity.
This warranty will not be modified or extended. Inovonics does not authorize any
person to act on its behalf to modify or extend this warranty.
This warranty will apply only to Inovonics Products. Inovonics will not be liable for any
direct, incidental, or consequential damage or loss whatsoever, caused by the
malfunction of Product due to products, accessories, or attachments of other
manufacturers, including batteries, used in conjunction with Inovonics Products.
Note: E-mail [email protected] for a copy of the CE Declaration of Conformity.
Top
View
Side
View