Inovonics EE1261 - Manual (Page 2)

© Inovonics, 2009 - www.inovonics.com, 3/18/09, P/N 7101855 Rev. D
a. If using the wall tamper function for increased security, mount the housing back plate per
Figure 3, ensuring the tamper switch is depressed..
Figure 3 EE1261 mounting back plate
b. If not using the wall tamper, mount the housing back plate using all appropriate hardware.
3 Optional Brackets
Optional wall and ceiling mount brackets, Inovonics part number ACC665, are available. The wall
and ceiling mount brackets must not be used for graded applications.
Figure 4 Ceiling and wall mount brackets
To mount a ceiling or wall bracket:
1.
Remove the pcb board.
2. Attach the housing to the bracket.
Figure 5 Remove the pcb board and attach the housing to the bracket
3.
Replace the pcb board.
3.1 Test the EE1261
Caution: The EE1261 should be tested after registration to ensure operation. To test the EE1261,
activate each of the conditions and ensure an appropriate response.
3.2 Perform a Walk Test
The walk test is performed to ensure motion is sensed and an RF transmission results. To perform a
walk test:
1.
Swipe the magnet past the reed switch. The five minute walk test will begin; every time motion
is sensed, the LED will light and the EE1261 will transmit a signal.
2. Walk in front of the motion detector to test the sensor.
3. After five minutes the walk test will automatically end.
4 Operation
The EE1261 transmitter signals an alarm condition when motion is detected by the sensor.
Figure 6 Standard mounting height and range
5 Specifications
Dimensions: 11.4 cm x 6.4 cm x 4.1 cm (4.5”H x 2.5”Wx 1.6”D)
Detection method: Quad element PIR
Storage temperature: -20° to 60°C (-4° to 140°F)
Operating temperature: -10° to 50°C (14° to 122°F)
Humidity: 0 - 90% (non-condensing)
Battery: 3V LiMnO2, BAT604 (Panasonic CR123A or Duracell DL123A)
Temperature compensation: Yes
Tamper: Housing and wall tamper
PIR RF interference immunity: Greater than 30 v/m 26 MHz - 1 GHz
Stabilization period: One minute
Alarm lockout time: Three minutes (in fixed, maximum mode)
Walk test period: five minutes
Mounting height: 2.1 to 2.7 m (7 to 9 feet)
Compliance: EN50131-2-2:2008; Security Grade 2; Environmental Class II;CE
6 Warranty/Disclaimer
Note: Changes or modifications to this unit not expressly approved by Inovonics Wireless
Corporation may void the installer's authority to operate the equipment as well as the product
warranty.
Inovonics Wireless Corporation ("Inovonics") warrants its EchoStream products ("Product" or
"Products") to conform to its own specifications and to be free of defects in materials and
workmanship under normal use for a period of thirty-six (36) months from the date of manufacture.
Within the warranty period, Inovonics will repair or replace, at its option, all or any part of the
warranted Product. Inovonics will not be responsible for dismantling and/or reinstallation charges. To
exercise the warranty, the User ("User", "Installer" or "Consumer") must work directly through their
authorized distributor who will be given a Return Material Authorization ("RMA") number by
Inovonics. Details of shipment will be arranged directly through the authorized distributor.
This warranty is void in cases of improper installation, misuse, failure to follow installation and
operating instructions, alteration, accident or tampering, and repair by anyone other than Inovonics.
This warranty is exclusive and expressly in lieu of all other warranties, obligations or liabilities,
whether written, oral, express, or implied. There is no warranty by Inovonics that Inovonics product
will be merchantable or fit for any particular purpose, nor is there any other warranty, expressed or
implied, except as such is expressly set forth herein. In no event shall Inovonics be liable for an
incidental, consequential, indirect, special, or exemplary damages, including but not limited to loss of
profit, revenue, or contract, loss of use, cost of down time, or interruption of business, nor any claim
made by distributor's customers or any other person or entity.
This warranty will not be modified or extended. Inovonics does not authorize any person to act on its
behalf to modify or extend this warranty.
This warranty will apply only to Inovonics Products. Inovonics will not be liable for any direct,
incidental, or consequential damage or loss whatsoever, caused by the malfunction of Product due
to products, accessories, or attachments of other manufacturers, including batteries, used in
conjunction with Inovonics Products.
Mount either
corner or wall
with screw only
Mount either
corner or wall
with screw and
wall anchor
Mount either
corner or wall
with screw only
Ceiling mount
installation Wall mount
installation
2.1-2.7m
15m