Inovonics FA422 - Manual (Page 7)

FA422 Installation Manual Page 7 of 11 02793.FM
Programming COMMAND (Arming) Transmitters
1. Plug the free end of the programming cable into the programming header on one of the Command transmitters. (Refer to
the transmitter’s user manual to access its programming header.) The two compatible transmitters are shown in Fig u re6.
2. Follow the "Adding RF Points" instructions in the D2000 Series Keypad Diagnostics manual to program an identification
code (ID) into the transmitter while leaving the transmitter’s factory default options unchanged. Stop when the keypad
display shows the following:
(where nn is the transmitter point number to be programmed)
3. Press the TRANSMITTER TYPE pushbutton one time. The flashing LED above this pushbutton should move from SECU-
RITY to COMMAND.
4. Continue to follow the Keypad Diagnostics manual’s instructions except that instead of pressing the transmitter tamper
switch, press the transmitter’s reset pushbutton switch to activate the programming. (Be sure the programming cable is
still connected.) Note that the COMMAND LED changes from flashing to solid. (See Figu re5.) This shows that the pro-
gramming was completed. (Note that Command transmitters are unsupervised and, therefore, no extended supervision
window changes are permitted.)
5. Remove the programming cable from the transmitter and put the transmitter’s cover back on.
6. Follow the above procedure to program all other Command transmitters.
FIGURE 6 FA100 and FA113 Command Transmitter
ACTIVATE
POINT nn
FA100
FA113