Inovonics FA104 - Manual (Page 18)

© 1994 INOVONICS Corporation
14
LIT-FA104-USER 14-Nov-95
Appendix C
C404 4-channel Slave Receiver Parameters
Default
Active on
Output Condition Programmable Options
1 Alarm Not programmable
2 Alarm "
3 Alarm "
4 Alarm "
Note: C404 outputs cannot be re-assigned to other points.
Transmitter
Default
Condition Mode
Alarm
Follower Follower / Momentary / Latching
Global Fault Latching (Not programmable) Latching only
Default Momentary Output time: 2 seconds
Default Receiver Parameters:
System
ID: (randomly assigned at factory) 0 - 255
Point supervision: Yes Yes / No
Supervision window: 240 minutes 0 - 240 minutes
Access code: 0000 0000 - 9999
NOTE: The C404 cannot be reset to default conditions. It must be reprogrammed.
Default Transmitter Parameters
Default Programmable Options
Transmitter
type Standard STANDARD
4-BUTTON TX (C100 REMOTE)
Contacts
Point 1: N/O NORMALLY OPEN / NORMALLY CLOSED
Point 2: N/O NORMALLY OPEN / NORMALLY CLOSED
Point 3: N/C NORMALLY OPEN / NORMALLY CLOSED
Point 4: N/C NORMALLY OPEN / NORMALLY CLOSED
End of Line Resistor No NO / YES
Internal
Contact No NO / YES
(C200W widegap magnet loop)
Check-In
period 60 Seconds 60 SECONDS
30 SECONDS
10 SECONDS
NONE