Inovonics FA130 - Manual (Page 2)

FA130 Keypad
The FA130 keypad is a 900MHz wireless transmitter used to arm and disarm
the Vision Plus™ or Wireless Guardian™ system. The FA130 is a one-way
device, which can be programmed as a supervised point. Functionally, the
FA130 emulates the KP130 hardwire executive keypad, without the LCD
display.
PROGRAMMING THE KEYPAD:
1. If desired, identify the point number of the unit with numbered labels
provided with the Vision Plus™ or Wireless Guardian™ panel.
2. Turn the phillips-head screw on the bottom of the housing slightly.
Separate the housing halves.
3. Complete program data entry as shown below Figure 1. When prompted
to "Plug in Xmitter", connect the programming cable between
programming headers on the hardwire executive keypad and the FA130
wireless keypad. Refer to Figure 2 to locate the programming header.
4. Press the reset button on the FA130 keypad. When programming has
been confirmed by the hardwire executive keypad, disconnect the
programming cable.
5. Test the FA130. Pressing any arming key will cause the keypad to
transmit and the transmit LED under the ENTER key to flash during
transmissions. The panel will decode the message to determine if it is
valid.
6. Mount the keypad using hardware provided.
3.
0V
+
RESET BUTTON
PROGRAMMING
HEADER
TRANSMIT LED
(SURFACE MOUNT CHIP)
Figure 2: FA130 programming
MOUNTING THE FA130
1. Turn the phillips-head screw on the bottom of the housing one turn.
Separate the housing halves.
2. Use supplied hardware to attach the FA130 securely to a wall.
3. Use the mounting holes in the backplate as needed to locate screws or
wall anchors.
MOUNTING HOLES
(4 PLACES)
Figure 3: back housing mounting holes