Jaclo York Column Ensemble - 1724- - Manual (Page 2)

READ THIS INSTALLATION AND CARE MANUAL
CAREFULLY
WEAR PROTECTIVE GLOVES
Components:
1. Upper frame
1a. Lower frame
2. Screws and Ø mm anchors
3. Shower tower cover
4. Shower head body
5. Flexible hose connection from manifold
to upper water supply
6. Fixation screws discs
7. Shower head cover
8. Flexible hose connection from manifold
to upper water supply
8a. Flexible hose connection from manifold
to lower water supply
9. Shower hose
10. Handshower
11. Shelves
2
YORK PANEL YORK PANEL
Prior to installation an in order to install the shower tower correctly
we suggest to check all dimensions and distances of water connections
(outlets) of the different options A-B-C as illustrated on pages 4, 5 and 6.
York tower shower allows three different installations solutions with three
different water outlets (newly installed or already exisiting) described below:
A) LOWER water outlet:
Connect the stainless steel flexible hose from manifold to lower water outlet
B) UPPER water outlet:
Connect the stainless steel flexible hose from manifold to upper water outlet
C) SIDE water supply:
Connect the stainless steel flexible hose to side outlet. The hose passes
through the hole located on the lower end of the tower cover.
Suggested height of the shower head from shower tray: 6'6"
Installation procedure:
1) Mount the lower frame on the wall (1a) making sure the frame is set
at right angles to the shower tray/floor. Mark the four holes and drill
using a ¼" bit. Insert anchors and secure the frame as shown in
illustrations 1, 1a, 1b and 1c.
2) Lean the upper frame (1) on the wall making sure it is perfectly straight.
Mark the four fixation screws and drill by using a ¼" bit. Secure as
shown in illustrations 2, 2a, 2b and 2c.
3) Assemble the two main bodies (3 and 4) fixing one to the other by
mean of the screws (6) and discs (6a); connect the flexible hose (5)
to showerhead.
4) Mount the whole tower assembly onto upper frame and temporarily
secure with screws (6). Leave enough space between tower and wall
in order to proceed to connections. First connect the flexible hose
connection to the designated water supply on the wall (A-B or C),
then proceed to final tower mounting: loosen the two screws (6) then
let the tower slide until it completely adheres to the wall.
5) Complete shower head assembly mounting the upper cover (7) and
secure the tower at the lower end with screws.
6) Connect shower hose (9) and handshowers (11) and mount shelves (12)
Cleaning metal parts:
For routine cleaning simply use a soft damp cloth and common household soap,
then rinse and dry. Proper care of your product is important because most water
contains calcium that deposits on surfaces, forming unpleasant spots. This can
be avoided by routine cleaning and drying after every use. Use only mild soap
based detergents.
Never use abrasive cleaners, disinfectants or cleaning
products containing alcohol, ammonia, hydrochloric or phosphoric acids as
they will damage the product finish.
Product Care
In order to maintain the high quality finish of the productyou have purchased,
please adhere to the following product care instructions.
Please note:
Your product warranty may not be valid if the above cleaning guidelines are not followed
11
IMPORTANT
Note: This unit requires a seperate shower control valve ie: thermostatic
or pressure balance valve to supply mixed water to unit.
Operation: This unit allows operation of the handshower, overhead shower
or waterfall all at the same time or individually by operation of
the three volume control valves mounted on the right hand side
of the unit.