Kistler-Morse KM Microcell Bolt-On - Manual (Page 16)

CAUTION
Only use Sikaflex 1A polyurethane sealant or
Dow Corning RTV 738 or RTV 739. Other
sealants may contain acetic acid, which is
harmful to sensors and electronics.
4. See Figure 3-13. In the bottom of the junction
box, locate one of the four small holes closest
to the terminal being used for that Microcell™.
Screw the watertight fitting into the hole.
Figure 3-13. Wiring Microcells™ to Junction Box.
Figure 3-12. Inserting Microcell™ Cable Through
Watertight Fitting and Cap
12