Kofax Export Connector 1.0.0 - Manual (Page 7)

Kofax Export Connector 1.0.0 for CMIS Administrator's Guide 7
Chapter 1
Installing the Export Connector
Kofax Export Connector for CMIS is intended for use with Kofax Capture or Kofax Express
to export documents to SharePoint, Documentum, FileNet, Alfresco, or any repository that is
compliant with CMIS 1.0. This connector supports on-premise or cloud export processing.
You can install the Kofax Export Connector for CMIS on a client or standalone workstation.
If you have an existing version of this export connector, you must remove it before installing
this version.
Important To install the Kofax Export Connector for CMIS, you must have Windows
administrator privileges. If you do not have administrator privileges and install this export
connector, error messages may occur.
Before you install the Kofax Export Connector for CMIS, refer to System Requirements for
information about installation requirements.
1 If you installed an earlier version of the export connector, remove it.
2 In the root of your product installation folder, locate and run Setup.msi.
The installation wizard appears.
3 Click Next and follow the instructions on the screen to install the export connector.
4 Once the installation is complete, click Finish.
5 Repeat the installation procedure on all Administration or Export workstations where
you plan to use the export connector.
The export connector is automatically registered with Kofax Capture or Kofax Express. See
Export Connector Setup .
Note If you plan to use Kofax Capture and Kofax Express on the same workstation, see the
Kofax Express Installation Guide for more information.
Removing the Export Connector
Use the following procedures to remove the export connector from Kofax Capture or Kofax
Express and from your computer.
Removing the Export Connector from Kofax Capture
Removing the Export Connector from a Batch Class
1 In the Kofax Capture Administration module, on the Batch tab, expand the batch class to
view associated document classes.
2 Right-click the applicable document class, and select Export Connectors.
3 On the Assigned Export Connectors list, select the export connector and click Remove.