Cobra Electronics 7700 - Manual (Page 5)

8 9
2. Powering the 7700 Pro using the built-in battery
Once the 7700 Pro is fully charged, it is ready for use. Press and hold the standby/power
switch on the top right side of the unit for 2 seconds to switch on the device.
WARNING
PLEASE DO NOT USE OR LEAVE THE 7700 Pro IN EITHER WET OR HUMID
CONDITIONS, OR IN EXTREME TEMPERATURES, AS THIS COULD PERMANENTLY
DAMAGE THE UNIT AND THE BATTERY. WHEN NOT IN USE DO NOT LEAVE THE UNIT
ATTACHED TO THE WINDSHIELD, ESPECIALLY WHEN THE WEATHER IS WARM, TO
AVOID DAMAGE TO THE UNIT AND ALSO REDUCE THE RISK OF THEFT.
CAUTION
THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED WITH AN
UNAPPROVED TYPE. USING THE WRONG TYPE BATTERY MAY DAMAGE YOUR UNIT
AND INVALIDATE YOUR WARANTY. ONLY COBRA AUTHORIZED PERSONNEL SHOULD
REPLACE THE BATTERY. PLEASE DISPOSE OF USED BATTERIES ACCORDING TO
LOCAL WASTE MANAGEMENT RULES AND REGULATIONS. FURRTHER INFORMATION
CAN BE FOUND IN THE USER MANUAL.
Battery
ON/OFF
switch
Power switch
To utilize the AURA™ Camera database you will need to register your
7700 Pro and perform a download. Please refer to ‘Registering your 7700 Pro,
‘System Requirements and Software Installation’ later in this Quick Start Guide
for further information.
Start Up
1. Charging the internal battery
To begin, make sure the battery ON/OFF switch on the rear
of the unit is switched to “ON”. Although the 7700 Pro can
be charged using the cigarette lighter in your vehicle, a
complete charge is more easily achieved by using the AC
charger included. When new, you must fully charge the
battery in your 7700 Pro before use.
To charge the unit fully, connect the AC charger as
indicated in the picture on the right. The battery light on
the 7700 Pro will illuminate and will take approximately
3 hours to charge. When the internal battery is fully
charged, the red LED will turn green. Once fully charged
the battery will last approximately 2 hours during
normal use.
Note: The new battery’s full performance is only
achieved after two or three complete charges and
discharges.
Plug the charger cable into the power
socket on the back of the 7700 Pro
Plug the charger
into an AC outlet
NAV7700_QSG.indd 8-9 8/5/09 8:14 AM